General engineering
Typical parts
Components we make for this sector. Others can be made to your drawing.
- Shafts and spindles
- Bushes and spacers
- Adaptors
- Threaded studs and pins
Supplier brief / General engineering3 requirements
- R01
Build-to-print
We work from your drawing and your tolerances, not a catalogue.
- R02
Low to high volume
From prototype lots to repeat production schedules.
- R03
Secondary operations
Cross-drilling, milling and knurling handled in-house.
Products for general engineering
- Size
- OD 3 to 65 mm, length 2 to 120 mm
- Material
- Brass, SS, MS
Turned Bushes & Spacers
Plain, flanged and stepped bushes and spacers turned to drawing.
- Size
- M2 to M16, length 5 to 150 mm
- Material
- Brass, SS, MS
- Threads
- Metric, UNC / UNF, BSP
Threaded Studs & Pins
Double-end studs, dowel pins, grooved and headed pins.
- Size
- M5 to M48, 1/8" to 2"
- Material
- Brass, SS
- Threads
- Metric, BSP, NPT
Hex Turned Adaptors
Male, female and reducing adaptors turned from hex bar.
- Size
- Ø 3 to 65 mm from bar
- Material
- MS
- Threads
- Metric, BSP, UNC / UNF
Mild Steel Machined Parts
Turned and milled MS parts for load-bearing and structural duty.
- Size
- M8 to M48, 1/8" to 2"
- Material
- MS
- Threads
- Metric, BSP, NPT
MS Adaptors
Mild steel thread adaptors, reducers and connectors.
- Size
- Ø 2 to 50 mm from bar
- Material
- SS
- Threads
- Metric, BSP, NPT, UNC / UNF
Stainless Steel Turned Parts
SS 303, 304 and 316 parts for corrosive, hygienic and outdoor use.
Sourcing general engineering parts?
Share drawings and annual volumes. We will propose the most economical process.